View Single Post
Old 5th December 2021, 14:40   #7
SudenKapala's Avatar
Join Date: Dec 2021
Location: The Jovian moon, Europa.
Posts: 92
Originally Posted by wdadli1 View Post
Every time I start Winamp 5.8, I get the UAC question about allowing the app to make changes to my device. Is there any way to stop this from happening? I tried giving full permission to Everyone (one of the solutions I found), but that didn't do the trick.
Any luck yet?

I had something similar recently, when installing other versions. But only just after a new install.

Did you try starting Amp (once) as an Admin? That did the trick for me; I reckon because it then could go through the post-install setup phase without hindrance. You probably tried this, but I wanted to be sure.
SudenKapala is offline   Reply With Quote