View Single Post
Old 31st December 2010, 12:12   #5
DrO
 
Join Date: Sep 2003
Posts: 27,873
rapidalbinopoker: the v2 tools are all comand-line based so you'll need to open a command prompt in the folder and then enter sc_serv conf_file (where conf_file is the path of the file you want to use - if it's not in the same folder as sc_serv.exe then you have to specify a fullpath instead of just the filename).

i would suggest finding a guide which you can follow and understand on using the command-line so you're happy using it before starting to use the current SC tools as they are heavily based on running from the command-line (is no more than the older v1 DNAS on windows did but without a wrapper around it).

-daz
DrO is offline   Reply With Quote